Lincoln Electric NERTAJET OCP 150, Инструкция по технике безопасности, эксплуатации и обслуживанию

Страница: 44 / 50

8695 9032 / R
I-38
OCP 150
I - UPKEEP AND MAINTENANCE
Before any servicing operation, shut down
the cutting installation.
1 - UPKEEP AND MAINTENANCE
OCP
plasma cutting torches are the seat of various phenomena which create
the plasma arc. To do this, they are supplied with :
- electric energy,
- plasmagene gas,
- cooling water,
- compressed air
Through means of a bundle of pipes and wires.
a) COMMENTS:

The normal wear of the nozzle and electrode limit the service life of these
parts, making their replacement necessary.

An error in assembly or leaving out a part can be detrimental to the service
life of the torch.

During disassembly or reassembly of parts equipping the torch, handle them
carefully in order to avoid breaking, scratching or marking them.
To carry out this work, use the tools in the
OCP
torch-kit,
reference W000325127.

Always use original manufacturer parts.
b) BUNDLE:
The bundle must be installed so that it is safe from mechanical, chemical and
heat damage.
Be careful of the condition of the bundle grouping sheath.
If it is defective, check the condition of the various conduits which make up the
bundle.
Also check the wire leading to the part (ground wire).
The upkeep and repair work on the envelopes, conduits and isolating sheaths
must never be carried out haphazardly.
Regularly check the tightening of all the connections and make sure that the
electrical connections do not heat up.