B. Synergic Welding Mode (LF 38 only)
Description:
During Synergic welding, the wire feeder determines the optimal voltage characteristics based upon the selected wire
type and diameter. Only the wire feed speed needs to be regulated by the user. The user can then adjust the height of
the arc using the right knob. Once the arc height has been established, it will remain at the same level regardless of any
variation in the wire feed speed.
Set-Up:
While pressing the
Prog
button, rotate the
Left
knob
and select from the
following:
While pressing the
Prog
button, rotate the
Right
knob and select the
appropriate wire
diameter:
Steel 80/20
0.8, 1.0, 1.2 mm
Stainless 98/2
0.8, 1.0, 1.2 mm
Metal Cored 98/2
1.2, 1.6 mm
Flux Cored 80/20
1.2, 1.6 mm
Flux Cored CO2
1.2, 1.6 mm
AlMg 100% Arg
1.2, 1.6 mm
AlSi 100% Arg
1.2, 1.6 mm
Innershield NR-211MP
1.7, 2.0 mm
Innershield NR-232
1.8, 2.0 mm
Innershield NR-400
2.0 mm
Innershield NS-3M
2.0 mm
•
Before welding (Pre-Set):
Pre-Set Wire Feed Speed
(Meters/Minute)
Adjust with left knob.
Pre-Set Relative Arc Height
100% is the baseline. This
value is often referred to as
Trim
. Adjust with the
Right
knob to increase/decrease arc
height.
•
During welding (Actual):
These actual values are displayed for
5 seconds
after the weld has stopped. Press
ENTER (LF 38 Only)
to recall these
values.
Actual
Welding Current
(A)
Actual Welding Voltage
(V)
English
English
5
