Lincoln Electric 8695 4791, Инструкция по эксплуатации

Страница: 17 / 42

11
User’s guide
7 - Console
The control console of the
Optitome
provides the operator with the
HPC3 Digital Process HPi
CNC control,
with all the controls required for starting up the machine and operating the cutting cycle.
The most used controls are located outside, in buttons on the front to make the machine and process easier
to control.
8 - Limit of supply
The customer must supply and install a device for isolating each source of energy (electricity, air,
gas and water). The devices must be clearly identified. They must be of the locking type.
The products AS-CM-OPT2D1530FL1 and AS-CM-OPT2D1530FL3 are delivered with:
•
1 400V 16A male connector for supplying power to the machine.
•
1 400V 125A male connector for supplying power to the power source.
To be paired with a female connector of the same type, offering adequate protection (data on the power
supply drawing).
The 125A connector has a pilot wire for switching off the upstream supply if the connector is disconnected.
That pilot wire must be wired to a contactor that controls the power supply to this connector.