IS 582 ECN 3851
Page 6 of 17
The appliance is type ‘A’. Rooms must be ventilated in compliance with existing
technical regulations. The airflow must not be less than 2 cubic metres per hour per
kW of installed capacity.
If the appliance must be fitted near walls, partitions kitchen furniture etc we
recommend they are made from non-inflammable material, otherwise they should be
covered with a suitable heat-resistant material. Full attention must be paid to fire
prevention regulations
If the supply pressure exceeds 37mbar for 3rd family gases then an external
regulator must be fitted at the appliance inlet
The water inlet must be between 50 and 300 kPa. The hose set supplied with the
appliance must be used– the old hose set is not to be re-used.
If this appliance is fitted with castors, use caution at all times when manipulating or
moving, and lock castors when appliance is in position. Drain the appliance BEFORE
moving it.
Connecting to a gas supply
Installation and connection to the gas supply must only be carried out by a technician
authorised by your local gas supplier. Before connection, ensure that the appliance
is suitable for the type of gas supplied. Ensure the gas supply is provided with an
isolating cock for emergency shutdown. Ensure that the supply hose shall comply
with the national requirements in force and shall be periodically examined and
replaced as necessary. These appliances are to be installed with sufficient
ventilation to prevent the occurrence of unacceptable concentrations of substances
harmful to health in the room in which they are installed.
Appliances fitted on castors must be suitably restrained to prevent strain on supply
hoses
WARNING : Black domestic hoses are not suitable for this appliance.
Once installation is complete, ensure all joints are leak free.
Earth and equipotential connection
The appliance must be connected to an equipotential system – the terminal is
situated near the entry point of the electrical supply cable and is marked by the
symbol
The appliance must be earthed. Connect the earth cable to the terminal near the
terminal block marked by the symbol
START THE APPLIANCE FOLLOWING THE OPERATING INSTRUCTIONS
Inspection of the gas supply
Check ignition and correct lighting of burners, pilot flame operation and check for any
gas leaks. Check the efficiency of the waste gas removal system and the operation
of aeration systems. If necessary, consult the section ‘Potential troubleshooting and
solutions’.