Lincar Annarita 698 TP-SAC, Инструкция по использованию и обслуживанию, Страница: 64 / 116

IT IT IT IT----GB GB GB GB----FR FR FR FR mod. 698 TPC– 698 TP-SAC
64/116
MENU 08 (status stove)
Within this Menu you can find some informations about the working of the appliance.
MENU 09 (pellet correct)
Sometimes, changing type of pellet, there are so many types of wood pellet on the market, the
combustion of the appliance can be affected. A clear signal of an unefficient combustion is
given by the quantity of pellets into the burner basket during the normal working phase: too
much or too scarce. It is possible to make some small regulations on the combustion of the
appliance. Under the assumption that during the working phase the burner basket should be
full of pellet from ¼ to half of its capacity, whenever necessary, you can make some
adjustments following the below procedures:
a- Observe the appliance and verify if the pellet is piling up till to the complete filling
of the basket or if the basket is emptying itself almost till to the extinction of the
fire.
b- Push on button 7 to enter into the Menu.
c- Run on the Menu utilizing the buttons 4 e 5 until you arrive to MENU 09
d- Push again on button 7 to accede to MENU 09.
e- An Access Key is requested, utilizing the button 2 run on the number in the upper
part of the screen until you arrive to number
33 .
f- Push again on button 7 to confirm the Access Key and to enter into the modality of
combustion modification.
g- Use buttons 1 and 2 to modify the number shown on the display on the upper part,
as indicated in the below tabel; to increase the quantity of pellet you must increase
the value, to decrease the quantity of pellet, decrease the value. ATTENTION! We
recomand to modify the value increasing/decreasing by only one number per time.
Verify the working of the appliance for one or two days, after having cleaned the
burner basket, only after this period of verification eventualy make a new
regulation.
h- Terminate the regulation of the combustion pressing shortly on button 3.
increase pellets decrease pellets
9 8 7 6 5 4 3 2 1 0 -1 -2 -3 -4 -5 -6 -7 -8 -9
MENU 10 (settings technic)
RESERVED TO TECHNICIANS.
DETAILS OF MENU
ATTENTION to the setting of the Time and the Date as they will affect the programmations
of the automatic switch ON/OFF
Menu 01 SET CLOCK - (setting up the clock inside the appliance).
Radiocontrol Display Description Example
DAY day of week TUESDAY
CLOCK HOURS hour of current time 15
( 15 :38)
CLOCK MINUTES minutes of current time
38
(15:
38
)
CLOCK DAY day of current date 10
(
10
/05/2012)
CLOCK MONTH month of current date 05
(10/ 05 /2012)
CLOCK YEAR year of current date
12
(10/05/
20 12
)
Pay attention to the value of parameters during setting up, because a wrong setting up will
cause anomalies in the automatic switch ON/OFF programs.