M10 screw nut
Screw barrel
Hanging
board
(upside down)
NOTE:
cont. installation
7
1. Before installation, make sure to switch off the main switch.
2. The ceiling must be able to support a weight of atleast 120kg
and the thickness of the ceiling must be equal of greater than 30cm.
3. Rangehood should be position at a distance of 65-75cm for optimal
efficiency.
Attach the screw cylinder to the hanging board
using 2 M10 screw nuts as shown below.
a
b
36cm
65-75cm
c
2
Attach 4 adjustable screws to the hanging board.
Align the screw and do not over tighten.
3
Pass wire ropes through the adjustable screws.
and fix using clamping screw and nut.
Make sure to measure ropes according to length
on step 1.
4
Mark the ceiling with (8) corresponding holes from
the hanging board. Then make holes using a drill.
5
Pass through the wire rope to the cover.
Match the hole for the power cord.
6
Secure the cover using the lock nut.
7
a - ceiling to floor distance =
Measure the distance between the ceiling ang the floor.
(refer to the image on the right)
b - cook top =
c - length of the rope =
1
1mm
1
2
www.linarie.com.au
