Page 17 of 31
Start-up (How to pair a Bluetooth
®
connection)
Getting started
It is possible to pair multiple controls to the TD5 via Bluetooth
®
.
If only one TD5 is to be paired with the control, ensure that only this TD5 is in pairing mode.
Pairing your control
1. Connect TD5 to mains via mains cable.
2. TD5 is in pairing mode for three minutes and Under Bed Light flashes to indicate this.
3. Press the two top buttons on LINAK
®
hand control at the same time.
The Under Bed Light gives one long flash to indicate that the hand control and the TD5 are paired up.
The TD5 stays in pairing mode and it is possible to connect more controls using the same procedure.
Note:
Wait 5 seconds after pairing control 1 before you can pair control 2.
To get the system out of pairing mode – simply press any button on an already paired control.
Allow for the hand control to go to power-saving mode (backlight turns off) before
disconnecting the actuator system from the mains supply.
Otherwise the pairing will not be saved in the hand control.
