Page 13 of 24
Mounting guidelines for the Desk Frame 2
Recommended tabletop:
Material
Veneered chipboard
Plywood
Thickness
Min. 21 mm (13/16”)
Size
Min. 700 x 1200 mm (27” x 47”)
Max. 1000 x 1830 mm (39” x 72”)
Table size and type
The DF2 is designed for T-desks and must be mounted centrally on the tabletop.
DF2 mounted centrally on the tabletop
Important:
The DF2 has a great feature which prevents overheating of the system. The temperature of the motor and the
electronics is calculated by the SW during use and it depends on load, run time, etc. The DF2 duty cycle is 5 % ≈ 1
minute continuous use at full load, followed by 19 minutes pause. If the DF2 is being used beyond the duty cycle, the
system gets hot and stops, and the DPG will show error code E90. After a few minutes break, the DF2 will be able to
run for another stroke. However, to cool down the system to factory settings, the DF2 must cool for at least 2 hours
with the mains plugged in.
Please note:
If you disconnect mains, the DF2 SW cannot work and thus not calculate the temperature. When the system is powered
on again, the SW will continue to calculate using the data from when the mains was disconnected.