User Guide Positioning Jack
1. Only use the transport dolly on an even floor with no
slope to prevent the raised vehicle from moving unin-
tentionally. Use the transport roller only for wheels up
to the maximum specified width and never for wheel
loads above the specified maximum.
2. Never start the car‘s engine while the car is liftet.
The hydraulic car movers are suitable only for
manual moving.
3. Do not attempt to push the loaded transport rollers
over obstacles. They are only suitable for smooth,
horizontal and unobstructed surfaces.
Attention: the positioning jack may only be pulled out in a horizontal posi-
tion, see photos. if the car mover is pulled apart at an angle or upright, air
might get into the hydraulic system.
!
Please read all
warnings carefully
before using positi-
oning Jack
OK
Bleeding the positioning jack
Open the valve and completely pull the transport roller apart 3-4 times in
horizontal position. Press it together again as far as it will go afterwards.
Then close the valve as soon as the positioning jack is fully extended and
pump it together by pedal and without load completely.
– 6 –
