LIMIT LIDD265, Инструкция по эксплуатации

Страница: 5 / 36

First use and installation
Cleaning before use
Before using the appliance for the first
time, wash the interior and all internal
accessories with lukewarm water and
neutral soap remove the typical
smell of a brand new product, then dry
thoroughly.
in order to
Installation Positioning
Warning! Before installing, read the
instructions carefully for your safety
and the correct operation of the appliance.
Position the appliance away from sources
of heat such as stoves, radiators, direct
sunlight, etc.
Maximum performance and safety are
guaranteed by maintaining the correct
indoor temperature for the class of unit
concerned, as specified on the rating
plate.
This appliance performs well from N to ST.
The appliance may not work properly if it
is left for a longer period at a temperature
above or below the indicated range.
and low power consumption.
sufficiently cleared
refrigerator
refrigerator
sides, a
height
For this reason,
e b d l u o h s e c a p s a
available around the . It is
advisable for there to be 75mm separating
the back of the to the wall at
least 100mm of space on its two
of over 100mm from its top and a
clear space in front to allow the doors to
open 160°.
Climate class Ambient temperature
SN
N
ST
T
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
Changing the light bulb
Warning! If the light bulb is
damaged, only a qualified electrician
must carry it out!
The changing of an
personnel
bulb by inexperienced
persons may cause injury or a serious
malfunction. It must be replaced by a qualified
in order to avoid a hazard. Contact
your local Service Force Center for help
Light bulb data: 220-240 V.
Thermostat
knob
Bulb (inside)
To switch off the appliance, set the
temperature regulator to position “0” or
un
Press the bulb in the center with finger.
Take out the lampshade with “1” type
screwdriver, change the bulb, and then
replace the lampshade.
Put the refrigerator back into operation.
plug the mains plug.
Lampshade
Important!
High ambient temperatures (e.g.
on hot summer days) and a cold setting on
the temperature regulator (position ) can
cause the compressor to run continuously or
even non-stop!
Reason: when the ambient temperature is
high, the compressor must run continuously to
maintain the low temperature in the appliance.
Before changing the light bulb, switch off the
appliance and unplug it, or pull the fuse or
the circuit breaker.
75mm
100mm
100mm
Important! It is necessary to have good
ventilation around the refrigerator to allow
for the dissipation of heat, high efficiency,
“MAX”
4