LIMIT 281130203, Руководство по эксплуатации

Страница: 8 / 104

6
Press measure the length of another hypotenuse (b).
Press measure the length of one leg (c).
Device calculates the length of the leg in full line (x).
Legs must be shorter than hypotenuse, or there will be "err" shows on screen. In order to
guarantee the accuracy, please make sure all measurements are start from the same point.
6. Addition/subtraction
The device can be used for length addition and subtraction.
Press , "+" shows in the major display area, entering cumulation mode. Value of last
measurement and the result of cumulation will be showed on the screen.
Press , "-" shows in the major display area, entering regressive mode. Value of last
measurement and the result of difference will be showed on the screen.
Not only distance but also area and volume can be added or substracted. For example:
Area addition: Measure the first area, get PIC 1, then press ; Measure the second area,
get PIC 2, there is a"+" on the left corner of the screen; At last, press get the addition
result as PIC 3.
PIC 1 PIC 2 PIC 3
Area sustraction: The same steps as above.
STAKING-OUT FUNCTION
Long press , the device switch to staking-out mode. As showed in the below picture,
the user can set two difference value a and b; User can adjust these two values by pressing
or . Long press or will make you get a large gap of the value when adjust a
or b. Press after setting the values, the device enter staking-out mode. User can get
instructions by sound and icon.
means the device need to go back, means the device need to go forward. When the
device get very near to the point, the device will show .
DELAY MEASUREMENT
Press , a second number shows in the screen as below picture. User can press or to
adjust the time. The max is 60 s, min is 3 s. Press to turn on the delay measuring function,
after certain the delaying time. If press while the laser is on, this function will be turned
on at once.
GB