lilitab Counter Basic Mount
Assembly Instructions v3.0
5
ASSEMBLY INSTRUCTIONS
2.
Center your mount arm.
After you thread
the USB cable through the bottom, pull the
other side through the top and allow some
give. Next, be sure the mount arm is posi-
tioned so that the center point of its rotation
is located appropriately for your installation
scenario. You can determine the center
point by aligning the openings on the rear of
the tube with the two screws visible through
the openings, as pictured.
4.
Install the base cover
by sliding the it gently
down to pole to cover the screws (velcro will
hold it in place once positioned).
5.
Set rotation tension.
To disable rotation
(and/ or adjust rotation tension) tighten
the screw in the upper rear opening of
the vertical tube to the desired level with
the
Silver L Key
provided.
3.
Install mount post.
Line up the bottom of the
lilitab mount with the four (4) screw holes in
the base plate. Secure together using the
four (4) 1/4-28 x 0.375 Compact Base Screws
.
NOTE: You will need to hold the foot cover up and out
of your way while securing.
1.
Cable routing.
Choose your method of how
you thread your USB cable that came with
your tablet:
A: Exit out the back of the base cover.
B: Exit through the compact base plate
(no wire showing). This will require cable
routing through your substrate.
A
B
