2
ADJUSTING LIMIT STOPS
After cable is installed and unit has been mounted, proceed as follow:
1. Plug control unit into a 117Va.c.(optional 230Va.c./24Va.c.) source. Be sure auto
switch is in the OFF position.
2. To adjust pan limit stops (see Figure 2), loosen screws securing both stops(1) and (3)
to unit. Slide stops around unit to desired locations and secure by tightening screw.
Right Pan Limit Stop
Limit-Switch Actuator
Left Pan Limit Stop
Camera Mounting Plate
FRONT
4-conductor cable for video signal
Connection to control
Video Output
MAINTENANCE
This pan and tilt drive requires no lubrication or maintenance for the life of the unit. If the
unit fails to function, turn it off and check the fuse on the control unit.
Replacement fuse valuse are given in the instructions supplied with the control unit.
Figure 2
