LikoScale™ 200 accessory
•
7EN160154 Rev 4
2
www.hill-rom.com I www.liko.com
Before assembly, make sure you have the following:
• Tool kit, 2 screws, 2 locking nuts
• User Guide from Liko
• 2 sleeves
• Operating and Service Manual from manufacturer
• Battery
• Declaration of Calibration
LikoScale 200 accessory is delivered with a 9 V battery with a battery life of about 3000 readings.
Installation of battery:
1. Open the door on the back of the scale.
2. Install the battery.
3. Close the door.
When the battery needs to be replaced, a small battery symbol will
appear in the upper left corner of the display.
NOTE!
Old batteries should be left at the nearest recycling station.
Assembly Instructions
Installing/replaceing the battery
LikoScale 200 accessory is delivered with two sleeves. The attachment type you have above and below the scale, and the
type of sling bar you have determines if both sleeves must be used. Follow the assembly instructions for the appropriate lift,
attachment point, and sling bar.
Viking
™
mobile lift, Uno
™
mobile lift: Fixed assembly with adapter
1. Remove the lifting accessory from the lift.
2. Mount the appropriate adapter (see previous page) on to the lift in accordance
with the assembly instruction.
3. Attachment point under the scale:
Alternative 1
with Universal sling bar
Place one sleeve on the scale´s lower attachment point.
Mount the lifting accessory under the scale, using bolt and locking nut provided.
Alternative 2
with Standard sling bar
Mount the lifting accessory under the scale, using bolt and locking nut provided.
4. Place one sleeve on the scale´s upper attachment point. Mount the scale in its
upper attachment to the adapter, using bolt and locking nut provided.
When disassembling the scale, the adapter must be removed from the lift before a lifting accessory is reassembled on
to the lift.
Viking
™
mobile lift, Uno
™
mobile lift:
Quick-release assembly
Liko lifts equipped with (Q-Link) quick fastener
require the Adapter Kit LikoScale,
Prod. No. 3156232.
1. Remove the lifting accessory from the lift.
2. Place one sleeve on the scale´s upper attachment point.
3. Mount the Adapter Kit LikoScale in accordance with the assembly instruction.
4. Mount the scale on to the lift.
5. Mount the lifting accessory under the scale.
Sleeve
Alt. 1
Alt. 2
Sleeve
Sleeve
Sleeve
