www.liko.com
Assembly Instruction
Monteringsanvisning
4.151.1
3 och 2,5 mm
Tools required:
2. Remove the locking screw
from the cover.
3. Remove the two locking
screws from the locking rail.
6. Disconnect both contacts.
Remove and covers.
.
4. Pull the locking
rail out.
7. Remove the cover from the
actuator.
8. Remove the battery.
9. Remove the locking screw. Pull
out the cover and clip from the
actuator.
10. Put together the Likorall in
reverse order
11. Mount the squeeze protection
between the switch and the cover.
12. Pull the strap to the highest
position. Feed out 10 cm. Mount the
strapstop on the liftstrap
5. Drive the liftstrap back a
little so you can see that the
drum is in line with the plate.
Pull the liftstrap out.
After changing actuator the lift must be tested with maximum load
Check squeeze protection .
1. Remove the scews from and cover.
Drive the liftstrap out to the maximum position.
200
10,87 mm
Actuator Restoration set LR 242
Motorpaket LR 242
Prod.no: 31290054
Doc. no: TI 31290054
2003-09-09
