www.liko.com
Assembly Instruction
Monteringsanvisning
4.79.1
Tools required:
4. Use the pin to lock the axle
where the strap was mounted.
5. Push the emergency lowering
handle down and pull the strap
away.
3. Remove the pin. Do not let
go of the springloaded wheel,
since the tension will release.
6. Pull the rest of the strap out and
remove the plastic housing.
7. Mount the new strap through
the plastic housing with the red
mark towards the plastic housing
and then as shown above.
8. Mount the strap through the slot
in the axle and the same way back.
Note!
The axle has two different
sides. Place the pin as shown to
lock the strap. Do not let go of
the springloaded wheel, since the
tension will release.
10. Roll up the strap until the red
mark reaches the plastic housing.
9. Push the plastic housing on to
the strap joint.
2. Hold the springloaded wheel
and release the strap by removing
the pin.
1.
Pull the strap all the way out .
Plasic Housing
Bandmagasin
Prod.no: 31190008
Doc. no: TI 31190008
2003-09-09
After changing plastic housing the lift must be tested with maximum
loadAnd the emergency lowering with 50Kg
