SMRI2
1.3 Mechanical safety
Install the device following strictly the information in
section “5 - Mounting instructions”;
mechanical installation has to be carried out with
stationary mechanical devices;
do not disassemble the unit;
do not tool the unit;
delicate electronic equipment: handle with care; do not
subject the unit to knocks or shocks;
protect the unit against acid solutions or chemicals
that may damage it;
respect the environmental characteristics declared by
manufacturer;
we suggest installing the unit providing protection
means against waste, especially swarf as turnings,
chips, or filings; should this not be possible, please
make sure that adequate cleaning measures (as for
instance brushes, scrapers, jets of compressed air, etc.)
are in place in order to prevent the sensor and the
magnetic ring from jamming.
2 - Identification
Device can be identified through the
ordering code
and the
serial number
printed on the label applied
to its body. Information is listed in the delivery
document too. Please always quote the ordering
code and the serial number when reaching Lika
Electronic for purchasing spare parts or needing
assistance. For any information on the technical
characteristics of the product refer to the technical
datasheet.
Warning
: devices having ordering code
ending with "/Sxxx" may have mechanical
and electrical characteristics different
from standard and be supplied with
additional documentation for special
connections (Technical Info).
3 – Overall dimensions
Figure 1 - Overall dimensions
4 - Installation
WARNING
Installation has to be carried out by
qualified personnel only, with power
supply disconnected and mechanical
parts compulsorily in stop.
Protect the device against knocks, frictions, solvents
as well as under and over temperatures. Please
never stretch the cable. Do not pull or carry by
cable. Do not use the cable as a handle. we suggest
installing the unit providing protection means
against waste, especially swarf as turnings, chips, or
filings; should this not be possible, please make sure
that adequate cleaning measures (as for instance
brushes, scrapers, jets of compressed air, etc.) are in
place in order to prevent the sensor and the
magnetic ring from jamming.
WARNING
Observe precautions for handling
electrostatic discharge sensitive
devices.
MAN SMRI2 I_E 1.3.odt
10
www.lika.it
www.lika.biz
