EMx58x...Txx...
User's manual
EMx58x ... TI1, TI2, TI3
EMx58x ... TV1, TV2, TV3, TV4
Table of contents
1 - Safety summary
2 - Identification
3 - Mounting instructions
4 - Electrical connections
5 - Output circuits
6 – TEACH-IN procedure
1 - Safety summary
Safety
•
Always adhere to the professional safety and accident
prevention regulations applicable to your country
during device installation and operation;
•
installation and maintenance operations have to be
carried out by qualified personnel only, with power
supply disconnected and stationary mechanical parts;
•
device must be used only for the purpose appropriate
to its design: use for purposes other than those for
which it has been designed could result in serious
personal and/or the environment damage;
•
high current, voltage and moving mechanical parts
can cause serious or fatal injury;
•
warning! Do not use in explosive or flammable areas;
•
failure to comply with these precautions or with
specific warnings elsewhere in this manual violates
safety standards of design, manufacture, and
intended use of the equipment;
•
Lika Electronic s.r.l. assumes no liability for the
customer's failure to comply with these requirements.
Electrical safety
•
Turn off power supply before connecting the device;
•
connect according to explanation in the “4 - Electrical
connections” section;
•
in compliance with the 2004/108/EC
norm on electromagnetic compatibility,
following precautions must be taken:
- before handling and installing, discharge electrical
charge from your body and tools which may come in
touch with the device;
- power supply must be stabilized without noise, install
EMC filters on device power supply if needed;
- always use shielded cables (twisted pair cables
whenever possible);
- avoid cables runs longer than necessary;
- avoid running the signal cable near high voltage
power cables;
- mount the device as far as possible from any
capacitive or inductive noise source, shield the device
from noise source if needed;
- to guarantee a correct working of the device, avoid
using strong magnets on or near by the unit;
- minimize noise by connecting the shield and/or the
connector housing and/or the frame to ground. Make
sure that ground is not affected by noise. The
connection point to ground can be situated both on
the device side and on user’s side. The best solution to
minimize the interference must be carried out by the
user.
Mechanical safety
•
Install the device following strictly the information in
the “3 - Mounting instructions” section;
•
mechanical installation has to be carried out with
stationary mechanical parts;
•
do not disassemble the encoder;
•
do not tool the encoder or its shaft;
•
delicate electronic equipment: handle with care; do
not subject the device and the shaft to knocks or
shocks;
•
respect the environmental characteristics declared by
manufacturer;
•
solid shaft: use a flexible coupling to connect the
encoder to motor shaft. Make sure the misalignment
tolerances of the flexible coupling are respected.
2 - Identification
Device can be identified through the
order code
and the
serial number
printed on the label applied
to its body. Information is listed in the delivery
document too. Please always quote the order code
and the serial number when reaching Lika
Electronic. For any information on the technical
characteristics of the product refer to the technical
catalogue.
MAN EMx58x TA I_E 1.2.odt
9
www.lika.it
www.lika.biz
