ES58 • EM58 MODBUS®
check box is not selected instead, you must press the
button to store the parameters permanently on the EEPROM after
setting (see on page 44).
In this section the items listed hereafter are available.
Counts per rev
It allows both to set a custom singleturn resolution of the device and to show
the value that is set currently. The value is expressed in counts. See the
counts per revolution [0000-0001 hex]
register on page 65. This register can
item is enabled (=1).
Total resolution
It allows both to set a custom total resolution of the encoder (total number of
measuring steps tailored for the specific application) and to show the value that
is set currently. The value to be set must be expressed in counts. See the
counts per revolution [0000-0001 hex]
register on page 65. This register can
item is enabled (=1).
Preset value
It allows both to set the preset value and to show the value that is set currently.
To execute the preset operation you must then press the
item at the bottom of the page: it executes the whole
sequence of preset commands (activation of the
and registers setting; deactivation of the
registers setting; save of parameters). Refer also to page 43. For more
information refer to the
Offset value
It shows the offset value which results from the setting of the
. For
Node address
As the node address can be set only via hardware (by means of the DIP switch),
this parameter is not used.
MAN ESx58x_EMx58x MB E 1.3
Quick reference
41 of 92
Содержание EM58 MB
Страница 90: ...This page intentionally left blank...
Страница 91: ...This page intentionally left blank...