Technical Description &
Configuration Guide
Status
Window
LigoWave
Page 33
LDPC is explained below in the chapter
LDPC
.
Radio data status
– shows if management CPU was able to read data from radio;
Radio side
– shows the radio side of local and remote LigoPTP 24 (command line –
radio side
);
Tx mute
– shows if transmitter is currently muted;
Tx power
– shows current transmitter power in dBm (command line -
radio status
or
status
);
ATPC
– shows the amount of current ATPC correction in dBm (command line –
atpc status
);
Rx level
– shows current level of received signal. It must not differ significantly from the previously
calculated value (command line -
radio status
or
status
);
Duplex shift
– shows the margin between the transmitting and receiving frequencies (command line -
radio status
);
Tx frequency
– shows the transmitting frequency (command line -
radio status
);
Rx frequency
– shows the receiving frequency (command line -
radio status
);
Configuration file
– shows which configuration the modem is currently using (command line –
modem configuration
);
Bandwidth
– shows width of currently utilized bandwidth in MHz (command line –
modem status
or
status
);
Modulation
– shows modulation mode set (command line –
modem status
or
status
);
Total capacity
– shows total capacity set (command line –
modem status
);
Ethernet capacity
– shows Ethernet capacity set (command line –
modem status
or
status
);
E1 channels
– shows the number of E1 channels set. The number must be equal at both ends
(command line
–
modem status
or
status
);
Modem data status
– shows if management CPU was able to read data from modem;
Modem status
– indicates the acquire status of the modem. „ACQUIRE_IN_PROGRESS‟ will appear
during start-up, when modem acquires required parameters, but in normal operation mode
„ACQUIRE_LOCKED‟ will be seen. Any other options designate failure (command line –
modem
status
or
status
);
Last acquire error
– indicates the reason of the modem acquisition error. In normal operation mode
„ACQUIRE_SUCCESS‟ will be seen,
any other option designates the reason of acquisition error
(command line -
modem status
or
status
);
Radial MSE
– shows radial mean square error value. Refer to the chapter
Radial MSE
for detailed
description (command line -
modem status
or
status
);
LDPC decoder stress
– shows the load of LDPC (low-density parity-check code) decoder. Refer to
chapter
LDPC
for detailed description (command line
–
modem status
or
status
);
ACM engine
– shows if ACM (Adaptive Coding and Modulation) engine is running (command line –
modem status
or
status
);
Current modulation Rx/Tx
– shows the modulation modes currently utilized (command line –
modem
status
);
Current total capacity Rx/Tx
– shows the current capacities in both directions (command line –
modem status
);
Current ethernet capacity Rx/Tx
– shows the current Ethernet capacities in both directions
(command line
–
modem status
);
Diagnostics data status
– shows if system parameters are in acceptable margins (command line -
diagnostics
);
System temperature
– shows the device internal temperature in degrees by Celsius (command line -
diagnostics
or
status
);
Modem temperature
–
shows the temperature on modem in degrees by Celsius (command line -
diagnostics or status
);
Input voltage
– shows the input voltage of PSU in volts (command line -
diagnostics
);
Current
– shows the current of PSU in amperes (command line -
diagnostics
);
