Lightware LW3, Руководство по установке

Страница: 6 / 9

Configuration Cloning
Setup Guide
Section 5. Important Notes Page 6/9
The progress is displayed in another window:
Step 6.
Reboot the device to apply the network settings after finishing.
6.
Important Notes
Static IP address
The backup file contains some lines with the network settings:
In the above example, line 465 indicates that DHCP is disabled, while line 469 shows the static
IP address of the appliance. If the file is uploaded to one or more devices, then the exact same
settings will be applied. To avoid a possible IP address conflict in the network, follow these steps:
Case 1
– Use DHCP in all the devices

Before the backup process: make sure that DHCP is enabled in the device, or

After the backup process: modify the backup file in a text editor (e.g. Notepad); search
for the following lines:
SET /MANAGEMENT/NETWORK.DhcpEnabled=false

SET /MANAGEMENT/NETWORK.DhcpEnabled=true
Info: The static IP address will be uploaded to the device if the referring line is in the backup file but
will be ignored when DHCP is enabled.
Info: The factory default IP address of the LW3 devices is static.
Case 2
– Use static IP addresses
Be aware that if the backup file is uploaded (restored) in multiple devices, it will cause an IP
address conflict. In this case you have to change the IP address in the backup file manually before
uploading it to each device; search for this line:
SET /MANAGEMENT/NETWORK.StaticIpAddress=192.168.0.80
Set the desired IP address and save the file.
Case 3
– Keep the original IP settings
If the Network settings of the destination device stay unchanged, then make sure that these lines
are deleted from the backup file, before you upload and restore it in a device. The network settings
are listed at the end of the file (the lines starting with
SET /MANAGEMENT/NETWORK
and
CALL
/MANAGEMENT/NETWORK
).