LIGHTOLIER a GENLYTE company.
631 Airport Road, Fall River, MA 02720
(508) 679-8131 FAX (508) 647-4710
© 1995
Read and understand these instructions before installing fixture.
This fixture is intended for installation in accordance with the National Electrical Code and local or Federal
code specifications.
To prevent electric shock, turn off electricity at fuse box before proceeding
.
Retain these instructions for maintenance reference.
IS:4511
0995
Instructions for Installation of Arco
Oval Series Fixtures.
Page 1 of 2
NOTE:
This instruction sheet covers both compact fluorescent and incandescent fixtures. Although illustration shows compact fluorescent, the
incandescent version assembles and installs in the same manner.
NOTE:
The
Backplate
is provided with (4)
Auxiliary Mounting Knockout
holes for direct mounting to wall surfaces. These can be used for
added security or where direct
Outlet Box
mounting is not
available. To remove plug in
Knockout
holes, follow steps 1 through
3 below. This
Backplate
can be mounted horizontally of vertically.
See Fig 1 below for proper orientation for type of
Lens Assembly
and desired position.
1.
Position blunt ended punch or awl in center of
Knockout
hole and
firmly hit with hammer to punch plug through. Repeat for remaining
Knockouts
(Fig. 1).
Caution
:
Always wear eye protection (safety goggles) when
removing
Auxiliary Mounting Knock-Outs
.
2.
Position
Backplate
in desired position over
Outlet Box
and mark
location of (4)
Auxiliary Holes
on wall surface.
3.
Determine the appropriate mounting hardware required for type of
wall material fixture is being mounted to (i.e. toggle bolts or molly
screws for plaster or gysum board walls, wood screws, etc.)
4.
Thread
Crossbar Mounting Screws
into
Crossbar
as shown in
Fig. 1.
5.
Using appropriate slots in
Crossbar
, secure
Crossbar
to
Outlet
Box
using
Outlet Box Screws
(provided with Outlet Box).
6.
While supporting
Backplate
make connections: black fixture lead
or fixture without tracer marks to hot (black) supply lead; white
fixture lead or fixture lead with tracer markers to neutral (white)
supply lead. Un-insulated wire is a ground wire and must be
connected to grounding terminals or ground lead inside Outlet Box.
Use
Wire Nuts
(local hardware item). Push connections back into
Outlet Box.
FIG.1
N
X.
OU
AU
T
T
N
U
O
M
U
A X.
U
E
L
E
R
FO
P
S
E
H
T
E
S
N
S
S
L
E
N
S
T
I
H
Wire Nut
Outlet Box
Crossbar
Outlet Box Screws
Ground Wire
Backplate
Gasket
Mounting Hole
Safety Cable
Battery Nut
Loop
Mounting Screw
Lens Assembly
Crossbar Mounting
Screws
Auxiliary Mounting
Knock-out
Position this edge of Backplate up for
horizontal mounting of these Lens Assemblies.
Position this edge
of Backplate up
for vertical
mounting of this
Lens Assembly