LIGHTNIN XDQ Series, Инструкция по эксплуатации

Страница: 19 / 48

LIGHTNIN
MIXERS AND AERATORS
®
REVISION
2001
DATE 3–16–83
REVISED 2–26–01
INST. NO. IT–1997
C
PAGE 9 OF 9
LIGHTNIN
MIXERS AND AERATORS
®
© ©
LIGHTNIN LIGHTNIN
b . Clean the mating surfaces of the motor (41) and the housing (36).
c . Place the O–ring (60) on the motor (41).
d . Align the motor rabbet with the opening of the housing, and lower the motor into place using care so
as not to damage the O–ring.
e . Align the motor and housing so that the switch, conduit box or junction box of the motor are opposite
the large opening on the front of the housing.
f . Align the screw holes and install the housing cap screws and washers (1, 2 & 20).
g . Rotate the drive shaft several revolutions by hand to make sure that all parts are running freely.
h . Reassemble the mixer shaft to the unit as described in the installation instructions.