1. Install the outer support on lightning fixture, tightened four wires.
2. Install the bracket of lightning fixture in desired position, weakened/ tightened a wire.
3. Connect the net wires, observing polarity: L – «brown», N – «blue», GND – «green/yellow».
4. Install control device CS LoRa-C-868 on the luminaire (for LORA series)
Install lightning fixture on bracket-type support or torchere support with a diameter of 48-60 mm
until tight, weakened/tightened two wires. Tightening force of wires is no more than 18Hm.
5. For lamp LED FREGAT PLC the label with the ID code of the included lamp, stick on the
column.
6. Installation of luminaries with bearing bracket (lyre).
7. Take off the outer support of lightning fixture, unscrewing four wires.
8. Install the light fixture support on the bearing surface.
9. Install the light fixture on support and fix him with the screws in the necessary position.
10. Power wires have been taken out of the casing through the cable gland and pressed in it. To
connect wires in accordance with the polarity “brown”- phase, “blue”- neutral, “yellow-
green”-grounding.
11. ATTENTION!
Check tightening and tighten if needed of the mains cable gland’s nut during installation.
LUMINAIRE LIFTING AND CARRYING BY MAINS CABLE IS PROHIBITED, doing this may
cause moist protection failure, cable and luminaire’s internal circuits damage.
These instructions assume expert knowledge corresponding to a completed professional
education as an electrician.
24
