Lightforce DL150LED, Инструкция пользователя

Страница: 6 / 8

6
USER INSTRUCTIONS
LIGHTFORCE.COM
STEP 4. INSTALL THE DASH SWITCHES
1. Find a suitable place on the dash to mount the
dash switches.
2. Affix dash switches by removing the adhesive
from the rear of the switches and attach to the
desired location.
• Switch 1 is for positioning lights
• Switch 2 is for high beam
STEP 5. CONNECT THE DASHBOARD
SWITCH LOOM
1. Route the dashboard switch loom connector
(on the driving light harness) carefully through
the vehicle’s firewall using pointy nose
pliers to pull the cable through. A flashlight
will help you to see what you are doing.
Be careful to avoid crushing the connector.
Ensure the wires are kept away from any
heat sources
2. Connect the dashboard switch loom connector
on the driving light harness (see item 1, figure
1) to the dashboard switch loom pictured in
Figure 8. Note: The notch on the switch loom
and wiring harness must be aligned.
If you are using a different switch with
dash illumination (not included), connect
the dash illumination cable (on the switch
loom) to your switch, as directed by the user
instructions for the switch.
STEP 6. CONNECT TO THE BATTERY
1. Connect the ring on the red wired battery
connector to the positive battery terminal
using a spanner
2. Connect the ring on the black wired battery
connector to the negative battery terminal
using a spanner.
STEP 7. SECURE CABLES
1. Use the supplied cable ties to secure all loose
cables and remove excess using wire cutters.
STEP 8. TEST
1. With ignition on check the following functions:
• The positioning light function is activating
with the ignition switch, ensure the switch 1 is
in the on position.
• With vehicles low beam switch on check that
the positioning light function dim to become a
night positioning light
• With vehicles high beam switch and check that
your spot lights only function when the high
beam switch is on.
OFF
ON
OFF
ON
Fig 8. Dashboard switch loom
Dashboard switch loom connector
Dash switch