Lightforce DL150LED, Инструкция пользователя

Страница: 5 / 8

5
OPTIONAL WIRING - POSITIONING
LIGHTS (switch one)
NOTE: This function will enable and disable the
positioning lights .
Refer to figure 1 for wire colours and identification
1. Locate the ignition signal wire in your vehicle
and connect to the spade terminal (#5) brown
wire (refer to figure 1)
NOTE: Ensure the ignition voltage is over 10 volts.
CONNECTING LOW BEAM PICK UP
For H4: Connect the blue wire (No.6) on the H4
path harness to the blue wire on the main harness.
For HB3: Using a multi-meter or test light locate
the Low Beam positive wire located on the back
of the headlight and fit the supplied T Tap over the
Low Beam positive wire. Figure 7
Two sizes of T Tap connectors are supplied in
the kit, the purple one suits small gauge wires
0.5-1.0mm2, the blue one is for heavy gauge wires
1.5-2.5mm2.
For HB3 and all other configurations (excluding
H4) cut off the existing bullet terminal on the end
of the blue wire (No.6) on the main harness, strip
5mm of insulation off the end and crimp one of the
supplied red insulated male spade terminals.
Connect the male spade terminal to the T Tap
connector ensuring it is full inserted
Fig 7. T-Tap Connection