Actual product characteristics may vary
www.lightculture.com.au
Slide neon through polycarbonate outer
sleeve, printed instruction aligns with the
‘Snap End’ arrow points in the direction of
the feed connector.
Place the anti-skidding clip on the very end
of the neon as shown.
Place the tip of the assistant tool against the
outer side of the internal circuit board within
the neon flex. Carefully push the tool into
the neon (max. depth of 12.5mm) so that it
creates a small cavity in the flexible material
on the outer side of the circuit board.
Insert rubber gasket into the pins and apply
100% clear silicone on the surface of it. Align
the front feed connector with the cut end part
and carefully push its pins into the gaps.
Ensure pins are going on the outer side of
the LED strip.
Gently yet firmly push the joiner bracket onto
the end cap assembly. The two parts close
together and eventually lock them into place.
Slide the polycarbonate outer sleeve until it
hits the flange of the front connector
R
NEON | SNAP CONNECTOR INSTALLATION - POWER FEED
The DIY snap kit has an IP67 rating. They can be fitted on-site, to allow flexible where lengths aren’t known prior to installation. Connectors can
only be used once, so ensure correct location before fitting. Neon can only be cut at specific cutting marks. End cap installation on next page.
R
R
FRONT FEED
CONNECTOR x 1
ANTI-SKIDDING
CLIP x 1
POLYCARBONATE
OUTER SLEEVE x 1
RUBBER
GASKET x 1
JOINER
BRACKET x 1
FINISHED ASSEMBLY
STEP 5
STEP 4
STEP 6
SILICONE
R
TOP
R
R
STEP 1
STEP 3
STEP 2
End requires an
R connector or R end cap
End requires an
L connector or L end cap
CUTTING & RIGHT OR LEFT END
Neon has cutting marks on the side or
bottom. These show locations where cutting
is allowed and the connector type required.
The snap connector letter needs to match
letter (R or L) with the end.
L R
L R
R
L
24V
24V
24V
+
+
+
Cutting mark
EXAMPLE FOR NEON X. NEON Y MODELS WILL HAVE PINS AT BOTTOM. PROCESS IS THE SAME.
7/8