Actual product characteristics may vary
www.lightculture.com.au
–
Avoid placing mechanical stress on the front connector cable
–
Do not curl or bend the front connector cable with excessive force
INSTALLATION SAFETY
–
Measure profile & cut to correct length
before installing to ensure connector has
>10mm space after profile and to avoid
connector being bend.
–
Leave 100mm or more after connector before bending Neon. Bending to
close can stress the connector and may lead to failure of the IP rating.
NEON Y | INSTALLATION & MOUNTING
<10MM
6/8
- Always ensure the supporting structure is a
flat and solid surface and can support the
weight of the product and any additional
wind or shear force. The supporting structure
must be suitable for the installation of
luminaries, and advice must be taken from
an appropriately qualified and competent
person to verify proposed mounting positions
and surfaces.
-
DO NOT
secure the product with staples,
nails, or alike that might damage the
insulation or PVC material. Aluminium profile
or mounting clips should be used.
-
DO NOT
install the product on/in places
where it is subject to continuous flexing.
Constant movement over time from weather
can cause damage.
-
DO NOT
leave any part of the product
unsecured.
- When installing into pools, ensure pool is not
in use.
- Although this product does not generate a
great amount of heat, it is recommended that
you do not cover or conceal it.
-
DO NOT
route the product through walls,
doors, windows, or building structures.
- The product must be installed within well-
ventilated areas.
- A minimum distance of 0.5m must be
maintained between the equipment and any
combustible surface. The mounting surface
must not be combustible.
-
DO NOT
bury product
-
DO NOT
operate/run the product in
temperatures exceeding 55°C.
-
DO NOT
operate the product over the
specified voltage or LED life degradation will
be greatly increased.
- During installation, violent pulling and
bending are prohibited.
>10MM
<100MM
>100MM