The supplied heat
shrink is adhesive
lined. Do NOT use
CA with this heat
shrink. Simply
position and heat.
If needed the tube
can be reheated to
reposition.
To create linkages
with minimal slop,
rotate the z-bend
around the control
rod. The intent is
to put the heat
shrink against the
control horn.
Control horns are included on
the polyfiber hardware card.
Be sure to use the horn with
notch for the elevator. The
notch fits over the carbon
stiffener. 2mm Carbon can be
cut to length for push rods.
Reheat the heat shrink as
needed to center surfaces.
