Control panel
The control panel and display allow the user to adjust settings as follows…
Press MODE to navigate through the options
Press ENTER to select an option and adjust value using UP and DOWN buttons
Press ENTER again to confirm setting
Control panel options
Display
Mode
Press ENT for
setting(press MODE
to exit)
Auto
Auto modes
Sound
Sound activated modes
d001
DMX start address
SLAU
Slave mode
Stand-alone modes
THE laser can operate in stand-alone mode one of 2 ways: Auto or Sound-activated
Auto Show / Stand Alone mode (Auto)
1 Press the function button (Func) to enter Mode options
2 Press the function button until the LED panel shows Auto
3 Press the Enter button to confirm the setting The laser will now be working in Auto Show / Stand Alone
mode
Sound Activated / Sound-to-Light / Stand Alone mode (Sound)
1 Press the function button (MODE) to enter Mode options
2 Press the function button until the LED panel shows Sound
3 Press the Enter button to confirm the setting The laser will now be working in Sound Activated
DMX mode
1 Press the function button (mode) to enter Mode options
2 Press the function button until the LED panel shows d001
3 Press the Enter button to confirm the setting or change the address using the Up and Down buttons 4 Press
the Ent button to confirm the setting The laser will now be working in DMX mod
DMX mode / DMX address setting
1
Ensure the unit is in DMX mode (see above)
2
Press the Up or Down buttons to adjust the DMX address
3
Press the Enter button to confirm the setting
If multiple connected units are to be controlled in exactly the same way, set all units to the same starting
address (e.g. 001). If individual control of multiple connected units is required, each unit must have its own
starting address. This address must be at least 10 channels apart e.g. set the first unit to 001 and the second
unit to 011, the third unit to 021 and so on. The DMX controller will now control all the connected units
separately.
