Flat Slab Setup Instructions
(See Owner’s Manual for Slope/Dual Slope)
Step 1:
Setup laser transmitter in appropriate jobsite
location (free from interference).
grade height.
Step 2:
Activate the ‘Outrigger’ function on the display.
Using the remote, extend both front outriggers
halfway to allow for maximum side shift capability.
Then turn off the ‘Outrigger’ function on the display.
Step 3:
Step 4:
Attach laser poles, laser eye receivers, and
cables to the screed head.
Step 5:
Drive to the 1st screed pass location.
Switch from
”DRIVE” mode to
“SCREED” mode.
Step 6:
Retract the undercarriage tight to the frame.
Adjust all 3 downriggers until machine is relatively
level or parallel to subgrade (using slope meter)
and there is approximately 3 inches (7.6cm)
between the tires and subgrade.
