Liftup A/S
| Hagensvej 21 | DK-9530 Støvring | Denmark |
T:
+45 96 86 30 20 |
M:
[email protected] | www.liftup.dk | CVR DK-1015 3964
USER MANUAL
–
RAIZER
–
EN VERSION 03.02
18
9.7
Pairing the remote control transmitter and receiver
How to reset transmitter and receiver:
To reset a remote control* so it is no longer associated with the Raizer, do as follows:
1.
Press the UP (
↑
) and DOWN (
↓
) buttons on the remote control* at the same time and
hold them down for approx. 5 seconds until the control LED on the remote control*
begins to flash slowly. The remote control is now in installation mode for 2 minutes.
2.
Perform the following within the 2 minutes:
Press: UP(
↑
), UP(
↑
), DOWN(
↓
), DOWN(
↓
), UP(
↑
), DOWN(
↓
), UP(
↑
), DOWN(
↓
)
When the control LED starts to flash quickly, the remote control* is no longer associated
with the Raizer.
Pairing of extra remote control*
1.
Ensure that there is power to the Raizer.
2.
The Raizer must be switched off
The device will switch off automatically after 10 minutes without use (it will emit a long
beep before powering down).
3.
Press the UP (
↑
) and DOWN (
↓
) buttons on the remote control* at the same time and
hold them down for approx. 5 seconds until the control LED on the remote control*
begins to flash slowly. The remote control* is now in installation mode for 2 minutes.
4.
Within these 2 minutes, switch on the lifting chair you require associated with the remote
control
*
by pressing the up/down arrows simultaneously on the side of the chair.
The control LED on the remote control* is associated with the lifting chair when it stops
flashing.
5.
Test the system so as to ensure the pairing has been performed correctly; if not, repeat 1-
5 above.
*Supplementary equipment
