Lifetime FRONT ADJUST 90599, Руководство по сборке

Страница: 36 / 44

32
X SECTION 6 (CONTINUED) TOOLS AND HARDWARE REQUIRED
To prevent serious injuries, two adults are
required to complete assembly. • Make sure the Backboard faces the playing surface and
align the small hole in the Middle Pole (ALF) with the correct slot in the Bottom Pole (ALE) . Slide the Middle Pole over the
Bottom Pole. Insert the remaining 1/4” x 3/4” Screw (ADS) through the Countersink Washer (CIH) and into the small hole in the Middle Pole.
ALE
ALF ALE ADS CIH
ALF
ADS (x1) CIH (x1)
• In order to seat the Poles, place the Scrap Wood on top of
the Pole and strike it very hard fi ve to six times with a Rubber
Mallet. This must be done even if the Poles cover the slots
before seating has occurred.
WARNING
The Poles must be seated together! Even if the Poles cover
the slots before seating, they must be struck on a hard
surface fi ve to six times! Failure to seat the Poles correctly
could allow the Poles to separate during use, which could
lead to serious personal injuries or property damage.
ATTENTION: THIS STEP CANNOT BE REVERSED! 6.4 6.5
• There are two screw holes at the bottom of the
pole. The correct hole will be slightly higher up on
the pole. The Screw will spin freely once installed. !
• If the Middle Pole does not completely cover the slot
on the Bottom Pole after seating, DO NOT COMPLETE
ASSEMBLY. Call our Customer Service Department. !
X SECTION 6 (CONTINUED)
TOOLS AND HARDWARE REQUIRED
To prevent serious injuries, two adults are
required to complete assembly.
• Make sure the Backboard faces the playing surface and
align the small hole in the Middle Pole (ALF) with the correct
slot in the Bottom Pole (ALE) . Slide the Middle Pole over the
Bottom Pole. Insert the remaining 1/4” x 3/4” Screw (ADS)
through the Countersink Washer (CIH) and into the small hole
in the Middle Pole.
ALE
ALF
ALE
ADS
CIH
ALF
ADS (x1)
CIH (x1)
• In order to seat the Poles, place the Scrap Wood on top of
the Pole and strike it very hard fi ve to six times with a Rubber
Mallet. This must be done even if the Poles cover the slots
before seating has occurred.
WARNING
The Poles must be seated together! Even if the Poles cover
the slots before seating, they must be struck on a hard
surface fi ve to six times! Failure to seat the Poles correctly
could allow the Poles to separate during use, which could
lead to serious personal injuries or property damage.
ATTENTION: THIS STEP CANNOT BE REVERSED!
6.4 6.5
• There are two screw holes at the bottom of the
pole. The correct hole will be slightly higher up on
the pole. The Screw will spin freely once installed.
!
• If the Middle Pole does not completely cover the slot
on the Bottom Pole after seating, DO NOT COMPLETE
ASSEMBLY. Call our Customer Service Department.
!