Lifetime FOOT ADJUST, Руководство по сборке

Страница: 28 / 44

24
TOOLS AND HARDWARE REQUIRED
X
SECTION 5 (CONTINUED)
5.6
5.7
• Use the measurement of the pole taken in step 1.5 to determine the hardware location for the Lifter Arm Bracket (EKC) . Use
the following chart to complete the assembly of the next two steps.
• Insert the Lifter Arm Bracket (EKC) to the Lifter Arm (EKB) , then secure them with the hardware indicated. Refer to the
chart in step 5.6 to determine which hole location to use in your assembly.
EKB
EKC
EKD
EJW
DHK
EKD (x1)
DHK (x1)
EJW (x1)
7/16” (x2)
(x1)
Pole Assembly Height
(in inches) Hole on the Bracket
(Step 5.7 and 5.8)
109 7/8” 3 and A
110 4 and B
110 1/8” 2 and A
110 1/4” 3 and B
110 3/8” 4 and C
110 7/16” 1 and A
110 1/2” 2 and B
110 5/8” 3 and C
110 3/4” 4 and D
110 7/8” 2 and C
111 3 and D
111 1/8” 1 and D
111 1/4” 2 and D
1 2 3 4 5 A B
C D
• The Coordinating Points refer to the location you will need to place
the hardware. For example, if your pole measures 110 1/2 inches
once seated, your coordinating points are 2 and B. In this example,
place Bolt EKD and Nut DHK from step 5.7 into hole 2, and place the
hardware from step 5.8 into hole B. If the rim still does not reach
ten feet, use the next set of holes down on the chart.
!
• Refer to the chart in step 5.6 for the
correct hole location in this step.
!
EKC
1.5
• Refer to Step 1.5 for Pole
Measurement.