background image

NOTE : LAMP STYLE WILL VARY WITH FIXTURE OPTIONS.

HEAD 

SCREWS 

(3X)

HEAD 

ASSEMBLY

THREADED 

GLOBE

LAMP

GLOBE 

GASKET

(IN RECESS)

CAUTION

WARNING : TURN POWER OFF BEFORE INSTALLING OR   

1.

PERFORMING ANY MAINTENANCE ON THIS FIXTURE.  

     Failure to do so may result in severe injury or death.

 

GFI PROTECTION!  Fixtures which may come in contact with or 

2.

be exposed to moisture (i.e. outdoors) shall be installed on a 

GFI (Ground Fault Interruptor) circuit. (120V only.)

 

The fixture should not be installed in low lying areas or where 

3.

water may accumulate and stand for long periods of time.

INSTALLATION

WARNING : Make sure the power is off before installing or 

1.

servicing this fixture.

Install the anchor rods into a concrete footing as indicated on 

2.

the supplied template.  Install and level the baseplate with 

ballast assembly as shown on the template.

Connect the supply lines from the supply conduit to the fixture's 

3.

input leads according to NEC procedures.  Tie the wires so they 

do not lie on the ground.  HID & Fluorescent : Connect the lamp 

supply quick-connect to the ballast quick-connect pigtail.

Set the fixture onto the baseplate and tighten the three 

4.

mounting screws to secure the fixture.  Be sure not to crimp any 

wires between the baseplate and tube.

Install a lamp per the relamping instructions below and test the 

5.

fixture for proper operation.

RELAMPING
Make sure power is off before relamping.  Loosen the three head screws on top of the head assembly until the

assembly is loose.  Lift the head assembly entirely off, lifting by the louvers, not the roof.  Unscrew the

globe and set it aside.  Replace the lamp or install a new one per the lamp style on the lamp label.  HID fixtures

should use coated lamps for best results.  Make sure the globe gasket is correctly seated, and securely replace

the globe.  Set the head onto the fixture and tighten the three head screws securely.

32000950, revision F

100 Craftway Dr.

Littlestown, Pennsylvania 17340-0128

Phone:  717-359-7131

INSTALLATION INSTRUCTIONS:

                 BOLLARDS

    This fixture is intended for installation in accordance with the National Electrical Code and local code

specifications.  Failure to adhere to these codes and instructions may result in serious injury and/or damage

to the ballast and void the warranty.  These instructions do not purport to cover all details or variations in

equipment, nor to provide for every possible contingency related to installation, operation, maintenance,

or mounting situation.  Should specific problems occur that are not addressed by these instructions, contact

your Sales Representative or distributor for assistance.  Retain these instructions for future reference.

page 1 of 2

SAFETY WARNING:

ALWAYS TURN FIXTURE OFF/DISCONNECT POWER AND ALLOW TO COOL BEFORE

PERFORMING ANY MAINTENANCE, INCLUDING RELAMPING AND CLEANING!

This fixture can become very HOT! The fixture housing and lens, especially if it is glass, can become hot enough

to blister hands. Attention should be paid to where the fixture is mounted, particularly if it can be touched by

children or pets. To help prevent premature failure, decreased performance, overheating and risk of fire, keep

fixture and lens clean and free of leaves, mulch, debris and mineral deposits from water. The fixture and lens

can be cleaned using a soft cloth and a solution of mild liquid soap and warm water. Wipe clean and dry with a

soft, lint-free dry cloth. Avoid polishing fixture or lens.

Отзывы: