7
s$ONOTCLIMBRIDEORPLAYONTHECART
s/NLYUSEONLEVELGROUND
s4HECARTSHOULDONLYBEMOVEDBYADULTSWHOCANHANDLETHEWEIGHTOFTHELOADEDCART
Failure to follow these warnings may result in serious personal injury.
The Center Deck Plates are designed to work with 5’ or 4’ Round Tables. For 4’ Round Tables, line up the Deck Plates
with the holes closest to the middle of the Cart. Insert the
m8 x 53 mm Bolt (CJC)
through an
m8 Flat Washer (CIX)
and through
each hole in the Deck Plates. Slide another Washer over the Bolts and secure them with
m8 Nylock Nuts (CIY)
.
For 5’ Round Tables, carefully remove the Bolts and Washers and slide the Center Deck Plates apart until they line up
with the holes closest to the ends of the Long Bars.
NOTE: The Deck Plates must be secured before moving the table cart.
ADJUSTING THE CENTER DECK PLATES FOR 4’ OR 5’ ROUND TABLES
a. Make sure the Cross Bars are pulled in tightly to the Uprights.
b. Insert a
m4 x 10 Self-Tapping Phillips Screw (CIZ)
into the holes in the Cross
Bar inside each Upright as shown.
c. Place a
Plastic Cap (CIS)
into the open end of each Upright.
d. Make sure all Nuts and Bolts are securely fastened before using the
cart.
CIZ
STEP 13
CIY
CIX
CJC
CIX
Keep hands and fingers away from pinch
points while adjusting the Deck Plates. The
Deck Plates may slide, resulting in serious
personal injury as listed on Page One. The
Deck Plates must be secure before moving
or rotating the table cart.
WARNING
WARNING
Part #FS02400
