Setting the Recording Mode
1. Press the navigating
or
keys to select " >Save Record" displayed on the
message bar. There are two modes, Auto or Manual, from which to select.
2. Press the OK button again and the message bar displays ">>Auto Save",
which indicates the measurement results will be saved automatically.
3. To change the saving mode to manual, press the navigating
or
keys to
switch to ">>Manual Sav” shown on the message bar.
4. Press OK button to confirm your final selection.
14
Setting the Time
1. To start the Time setting, press the
or
keys to select ">Set Time".
2. Press the OK button and the message bar will flash ">>SET YEAR". Press the
or
key to change the year.
3. Press OK to confirm the year. The device then tabs to the month. Repeat
the above steps to set month, date, hour, minute and seconds in sequence.
It is recommended to select the Auto Saving mode. If you select
the Manual mode, however, the message bar will show "Save? Yes"
after taking your measurement, and you can press OK button to
save data, or press the navigating
or
keys to select "Save? No",
then press the OK button to cancel the saving.
Setting the Heart Beat Sound
1. This setting turns on a corresponding sound beep each time the BPM1000i
detects a pulse. The default setting is "OFF".
2. To trigger the heart beat sound, press the navigating
or
keys until
">Heart B. Snd" displays on the message bar.
3. Press OK
to enter the setting. The message bar displays ">>Sound OFF".
4. To change the sound mode, press the navigating
or
keys to switch to
">>Sound ON" and the LCD will display the icon.
5. Press the OK button to confirm your final selection.
