16
7.
You may remove the defective bulb by simply sticking your 2 hands between
the tinsel and the heater’s lower panel (there is plenty of room, since the
tinsel is harmless and flexible). Use one hand to stabilize the bulb holder, and
the other hand to simply pull the bulb straight out of the holder. It may be
snug at first, but there is no twisting, unlocking, or major “jerking” needed
for removal.
8.
Replace with T4 shape/ G9 base 25 watt bulbs only (qty 2). If unsure if you
have the correct bulbs or if you cannot find elsewhere, you may always
obtain or purchase from Lifesmart Technical Support. Do not exceed 25W
per bulb as excessive heat may occur.
9.
Make sure that once the bulbs are replaced, that the tinsel strip (if you flexed
it to gain access) is perfectly straight before re-installing the rear metal cover.
This will avoid warped flame patterns and noises from the flame effect motor.
Once the bulbs are replaced, re-install the metal cover with the 7 perimeter
screws.
10.
Your fireplace is now ready to be tested.
