EN
11
MAINTENANCE AND CARE
How to clean the bottle, whilst indoors
in a clean environment
• Unscrew and remove the pump base
from the bottle.
• Place your hand over the base of the
bottle and turn the bottle to the vertical,
upright position with the screw top
facing upwards.
• Unscrew and remove the screw top
from the bottle shell, at the same time
this will cause the cartridge to drop into
your hand. Remove the cartridge from
the bottle shell and place the bottle shell
on a flat surface.
1
• Screw the screw top directly onto the
cartridge end ensuring the snap-fit lid is
closed; this will prevent contaminated
water from entering the sterile water
area of the cartridge during cleaning.
• Soak the cartridge in a basin of warm
water for 30 minutes. Gently move the
cartridge through the water to dislodge
any dirt or debris.
2
• Rinse the cartridge with clean running
water and leave to drain for 4 hours in
cool conditions.
• Whilst the cartridge is draining, wash all
of the plastic components with a mild
detergent solution in warm water with
a soft cloth. Rinse thoroughly under
running water and drain for 1 hour.
• Now reassemble the bottle. Remove the
screw top from the cartridge end. Turn
the bottle shell to the vertically down
position and insert the bottle cartridge.
1
2
• Twist the cartridge until you feel the
cartridge engage in the 4 locators in
the neck of the bottle shell. Hold the
cartridge in place with one hand and
screw the screw top into place. Close
the snap-fit lid.
• Re-screw the pump base into the bottle.
