Lifesaver 4000UF, Инструкция по эксплуатации

Страница: 13 / 20

replacing your activated carbon
filter
The activated carbon filter is made of
high specification activated carbon which
reduces a broad spectrum of chemical
residues including pesticides, endocrine
disrupting compounds, medical residues
and heavy metals.
It is designed to last for approximately
250 litres.
1. Empty LIFESAVER bottle of water.
2. Install pre-filter disc in base of bottle
and firmly screw up base.
3. Pump the handle 30 times.*
4. Unscrew the cap.
5. Unscrew the old activated carbon filter
and replace with a new one.
6. Firmly screw up the cap.
7. you may now slowly unscrew the base.
8. If this proves difficult leave the teat in
the open position for a few minutes and
try again.
After any trip and or when storing
LIFESAVER bottle the activated carbon
filter should be removed and discarded.
Only replace with a new one immediately
before your next trip.
MAINTENANCE
AND
CARE
UK
iMPOrTaNT!
Do not replace your carbon
filter in the field unless
absolutely necessary. When
replacing the carbon filter you
must follow these instructions.
Failure to do so may cause
contaminated water to pass
through to the drinking water
side.
Leaving the activated carbon
filter inside the bottle whilst in
long term storage may cause
microbiological growth to
occur. This will not have come
from the bottle but may come
from the user’s saliva. Always
remove and discard the
activated carbon filter when
storing LIFESAVER bottle
long term.
13
*
iMPOrTaNT!
If you do not pump the handle 30 times the
cartridge will disengage from the seal and
you risk contaminating the clean water side of
the bottle.
Do not over tighten the
activated carbon filter as
this risks damage