model no.
IFH1
2
A-75
6
INSTALLATION INSTRUCTIONS
HARDWARE NEEDED
You will need the following hardware, which can be purchased from your local hardware store or electrical
supply house:
• Adequate gauge and length of wire for your application.
• Proper size fuse or breaker to handle amperage.
• Proper wire connectors for your application.
• Fasteners appropriate for application that are strong enough to hold the unit.
MOUNTING THE HEATER ON THE CEILING
1.
Locate a wood stud in the wood ceiling joist. If you cannot locate a wood stud, you
have to install a
wood piece on the ceiling as this heater must be securely fastened.
2.
Remove the mounting bracket from the heating unit by loosening bracket screws
with a wrench and
slipping the handle off over the screw heads.
3.
Place a washer on screws before inserting through the holes in the mounting
bracket and screw them
securely into a ceiling joist.
NOTE:
If you want to swivel the heater either to the right or left, adding a washer to both sides of the bracket is recommended. A longer lag bolt may be
required to properly secure the unit.
HANGING THE HEATER
1. Lift the heater up and into the mounting bracket.
2. Align the bracket screws with the keyhole slots in the mounting bracket.
3. If the heater is to be tilted it must be positioned in the keyhole slots.
4. Tighten the bracket screws with a wrench so the unit is securely suspended at
horizontal or vertical level.
