model no.
IFH1
2
A-75
4
SAVE THESE INSTRUCTIONS
GENERAL SAFETY INFORMATION
1. Use only copper wires rated for at least 75ºC.
2. Heater airflow must be directed parallel to or away from adjacent wall.
3. Observe wall, floor and ceiling clearance
requirements.
4. All wiring must be done according to applicable national and local electrical codes
in the United States and Canada. The heater must be grounded as a precaution
against possible electric shock. Heater circuit must be protected with proper fuses.
5. The mounting and anchoring hardware must be capable of reliably supporting the
weight of the heater and its mounting bracket.
6. All electrical power must be disconnected and the main service box must be
locked before inspecting cleaning or servicing the heater. This precaution must be
followed to prevent serious electric shock.
7. This heater is not suitable for use in hazardous locations as defined by the
National Fire Protection Association (NFPA) in the United States. This heater has
hot and arcing sparking parts inside. Do not use it in areas where gasoline paint or
fl
ammable liquids are used or stored.
8. This heater is not suitable for use in corrosive atmospheres such as marine
greenhouses or chemical storage areas.
9. This heater must be mou
nted at least 8' (2.44 m) above the floor.
WARNING:
This heater requires hardwire installation (no plug). The installation of this product must
be carried out by a certified electrician in accordance with all applicable local and national electrical codes.
Read and understand all installation and operation instructions prior to operating this unit. Observe all safety instructions.
Improper installation or failure to follow the procedures outlined in this instruction manual can result in serious electric shock.
NOTE:
Compatible with a 240 V line voltage single pole wall thermostat. This thermostat must be installed by a certified electrician.
