lifelong Fit Lite Airbike, Руководство пользователя

Страница: 5 / 9

OPERATION:
STEP 4: Install the pedals.The right pedal (part R) is marked with an ‘R". The left pedal
(part L) is marked with an "L". It is important that each pedal goes on the proper side.
Select the right pedal. Slide a two step pedal bushing on to pedal first then slide a ball
bearing next to the bushing. Now screw the pedal stem into the right pedal arm. Right
pedal lightens clockwise. You must secure it tightly. Screw on to the pedal's stem the
lock nut (SILVER) until tight. Rotate the handlebar's link arm to meet the pedal. Bring the
" C ” slot on the link arm up from the bottom to hock on the bearing on the pedal stem.
Now place the " C " clip locking the link arm on the bearing.
STEP 5: Mount seat (part F). Remove nuts and
washers from studs on bottom of seat (F). Place
seat onto seat post (G) and replace washers
and nuts. Secure tightly. Select seat height
adjust knob (K), slide the seat post bellow onto
the seat post first then slide the seat post into
main frame aligning a set of holes in the seat
post with the seat height screw hole.
Screw in seat post knob. Secure tightly.
STEP 6: Mount monitor (part H). Insert batteries
into battery holder being sure to follow battery
diagram. Check to be sure monitor shows a
display. If it does not, check batteries and
battery installation. Plug monitor cable (part J)
coming from main frame into back of monitor.
Slide monitor on to the main frame.
1. LEVELING THE BICYCLE EXERCISER.
Place the BICYCLE EXERCISER in the location it will be used. The floor should be hard
and flat and the bike should sit firmly on the floor. If the bike is not stable, turn the end
caps on the front strut (part C) until the bike is stable. Turn one end cap at a time as it
may only be necessary to adjust one.
7
8