9
․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․․
Step 4
Attach the 50x50xt1.5-Ø25xt1.5 Leg Developer (7) onto the 50x50xt1.5 Main Seat Support
Frame (4) with one M10x75 Bolt (36), one M10 Nylon Nut (29), and two Ø10 Washers (31).
Tighten bolt and nylon nut with two 14-17 Wrenches provided. Then cover the M10x75
Bolt (36) and M10 Nylon Nut (29) with two M10 Caps (28).
Install one Ø25 Spring Clip (14) onto the weight sliding tube of the 50x50xt1.5-Ø25xt1.5 Leg
Developer (7).
Insert the
Ø25x1.5x380 Foam Roller Tube
(11) through the hole in the
50x50xt1.5-Ø25xt1.5
Leg Developer (7)
, leaving room on each side for the
Ø80x160 Leg Developer Foam Rollers
(17
). Slide both
Ø80x160 Leg Developer Foam Rollers (17
) onto the
Ø25x1.5x380 Foam
Roller Tube
(11).
Use the same procedure to install the other
Ø25x1.5x380 Foam Roller Tube
(11) and
Ø80x160 Leg Developer Foam Rollers (17
).
Press the button of the Ø22 V-Spring (15) of the 50x50xt1.5 Left Butterfly Arm (5) and then
insert the tube of the 50x50xt1.5 Left Butterfly Arm (5) into the hole of the 50x50xt1.5 Upright
Beam (1) until the button of the Ø22 V-Spring (15) "pops" down into the locked position.
Install one Ø25 Spring Clip (14) onto the weight sliding tube of the 50x50xt1.5 Left Butterfly
Arm (5).
Attach the Ø25x1.5x185 Butterfly Arm Foam Roller Tube (9) onto the 50x50xt1.5 Left
8 Washers (Ø6)
4 Bolts (M6x35)
4 Bolts (M6x40)
14
1
1
5
17
17
16
9
34
31
14
15
6
11
7
4
29
28
31
31
28
36
2 Wrenches (14-17)
Tool:
