11
4. Handlebar, Front/Rear Decorative Covers for Handlebar Post, and Computer
Installation
Place the Handlebar (4) through clamp on the top end of the Handlebar Post (14). Connect
the Extension Sensor Wire (13) from the Handlebar Post (14) to the Extension Sensor Wire
(13) from the Handlebar (4).
Hold the Handlebar (4) in desired position and fasten
Front/Rear Decorative Covers for Handlebar Post (12, 15), M8x75 Handlebar T-Knob (9),
and Ø12x1.5x50 Spacer (10) onto clamp and tighten Front/Rear Decorative Covers for
Handlebar Post (12, 15) with one ST4.2x20mm Screw (7) and eight ST2.9x16mm Screws
(3). Tighten screws with the Multi Hex Tool with Phillips Screwdriver provided.
NOTE:
M8x75 Handlebar T-Knob should be tightly secured before using.
Connect the Hand Pulse Sensor Wires (6) and Extension Sensor Wire (13) to the wires that
come from the Computer (1). Then install the Computer (1) to the Handlebar (4) by
inserting the Computer (1) into the Handlebar (4), using two ST4.2x20mm Screws (7).
Tighten screws with the Multi Hex Tool with Phillips Screwdriver provided.
Hardware:
Multi Hex Tool with Phillips Screwdriver
S10, S13, S14, S15
Tool:
6
9
10
1
4
7
15
12
3
7
3
3
7
13
6
14
13
(7) Screw ST4.2x20mm
3 PCS
(3) Screw ST2.9x16mm
8 PCS
