6.
Composition and layout
WARNING: Before lifting the surface, the incline of the treadmill must be in the starting
position.
Composition:
First turn off the machine and unplug the power cord. Grasp the back of the frame and
lift the board until the lock locks into place. Now you can move the machine using the
knobs.
Caution: Make sure the board is ensure before handling the machine. Do not turn on
the machine.
Layout:
Hold the back of the frame with one hand and then push by the feet slightly against
the top of the folding structure away. The board then automatically starts to run.
Caution: Do not stand under the treadmill when unfolding.
7.
Checking V-belt and treadmill settings
If you seem to slip the treadmill, the next steps will determine which part is a release
and needs to tighten, if it's a running belt or a V-belt on the engine.
1.
Turn off the main switch off and unplug the power cord (out of the socket). Loosen
the side bolts on the engine guard and take down the cover.
2.
Turn on the treadmill again and set the speed to approximately 3km / h. Stand on
the belt and pull it firmly (pressure) to stop it.
3.
If the belt is paused along with the front roller, it means that is neccessary has to
be tensioned the V-belt.
4.
If the treadmill (area) is stopped but the front roller is still spinning it means After
completing this check and setting, screw the engine protection cover.
8.
Adjustment of the treadmill and adjustment the treadmill
deviation
Turn the two screws at the ends of the belt in the same direction by half a turn. If the
belt area still slips, repeat the previous step. At this adjustment, you can start the belt
