Page | 5
Step 1: Front & Rear Stabilizer Assembly
1) Locate the front stabilizer hardware bag
labeled Figure 1. Screw in the black
stabilizer pads to the bottom of the
stabilizer tubes #2 & #3.
2)
(
See Figure 1
) Attach the front
stabilizer tube #(3) to the main frame
#(1). Secure it with two M8x45
3)
Attach the rear stabilizer tube #(2) to
the main frame part #(1). Secure it
Step 2: Console and Console Mast Assembly
1) Locate the console mast hardware bag
labeled Figure 2.
2) (
See Figure 2
) Connect the lower console
wire #(75) to the main wire #(70).
Note:
Ensure that all wires are properly connected
and stored inside the console mast tube. Be
careful not to pinch the wires.
Carefully insert
the console mast #(5) down onto the main
frame #(1). Secure and tighten the mast with
four button head bolts #(40), and four arc
washers #(66). Use the 5mm Allen wrench to
tighten the bolts.
3)
Locate the console #(26), install the two
AAA batteries into the back of the
console. Unscrew the preinstalled four
round head screws #(44) & washers
#(50)
.
Connect the console wire #(75) to
the console #(26). Join the console to the
console mast with screws #44 & washers
#(50)
.
4)
Locate the water bottle holder. With the
provided screw driver, remove the
preinstalled screw #(31) from the console
mast. Secure the water bottle hold to the
mast.
Figure 1
Figure 2
2
3
1
30
30
59
59
67
67
59
59
30
30
80
31
50
44
50
44
75
26
5
66
66
40
40
75
70
1
carriage bolts #(30), two washers
#(59) and two acorn nuts #(67).
with two M8x45
#(30), two washers #(59) and two
acorn nuts #(67). Use the 13mm
wrench to tight all four nuts.
carriage bolts
