EN26
EN27
3. Press the (V) button to switch the warning lights on
or off.
Batteries
Caution:
New batteries must be run in. The full capacity
of batteries is only reached after they have been
used and charged a couple of times. Take this into
account during your first few trips.
Charge the batteries every day if you drive a lot,
and every few days if you drive little. This will
extend the service life of the batteries.
Always charge the batteries to full capacity.
Avoid draining the batteries completely. The
mobility scooter will lose power which will have a
negative effect on the service life of the battery.
Charge fully drained batteries as soon as possible
using a 24hour cycle.
Do not keep your batteries fully drained for a
prolonged period of time.
Never put metal parts on the batteries: this may
shortcircuit the batteries and damage them.
Attention:
At lower temperatures the capacity of the batteries
is reduced. This also reduces the operating range.
Always connect the charger when putting the
mobility scooter away for the night.
You cannot overcharge the batteries supplied.
Thanks to a voltage limiter, the charger
automatically switches off when the batteries are
full.
Only use Life & Mobility battery chargers.
If you use batteries other than the batteries
supplied by Life & Mobility ensure that a good
retaining ring is fitted to prevent them moving. If a
retaining ring is not fitted this could lead to short
circuiting.
Driving forward and reversing
1. Slowly squeeze the throttle lever (f)*.
The mobility scooter starts moving
forwards.
2. Squeeze the throttle lever further.
The mobility scooter will start moving
forward more quickly.
3. Release the throttle lever.
The mobility scooter will stop. The
brake lights are activated.
4. Use lever (Y)* to reverse.
Stand-by button / Stop button
The standby button / Stop button (U) has two
functions:
The mobility scooter is temporarily ‘switched
off’. You can then reach over the handlebars
safely without turning the ignition key. The
drive controls are switched off, preventing
you from driving off unintentionally.
If you use the standby button / stop button
while driving, you will come to a standstill
more quickly.
Lights
Attention:
After a tight bend the indicators automatically
switch off.
Your dealer can set up onehanded controls
for you.
Your dealer can disable the default sound
from the warning lights.
1. Press the (i) button to switch the lights on or
off.
2. Press the (b) or (d) button to switch the
indicators on or off.
* Depending on how your mobility scooter has
been set up.
Standby button / Stop button
activated
GaÊladen
MENU
10:24
0.3Êkm
MENU
10:24
0.3Êkm
MENU
10:24
0.3Êkm
0
MENU
10:24
0.3Êkm
km/u
MENU
AFSTANDEN
TOTAALÊÊ19ÊKM
TRIPÊÊÊÊÊÊÊÊ0ÊÊKM
MENU
TIJD,DATUM
10:24Êuur
25ÊJanÊ11
MENU
INSTELÊTIJD,DATUM
10ÊÊ:ÊÊ24ÊÊÊÊÊuur
25ÊÊÊJanÊÊÊÊ11
MENU
STOP
MENU
RESET
Control panel
b
c
d
e
f
g
h
i
V
U
W
X
a
Z
Y
Use
Use
