Lifan LFQ3690-CA, Инструкция по эксплуатации и руководство пользователя

Страница: 28 / 50

27
Operation of Pressure Washer
STARTING THE ENGINE :
Refer to the Controls and Features section for additional diagrams and definitions.
Do not run Pressure Washer without proper inlet water supply to high pressure pump and for more than
1 minute without depressing trigger on gun to circulate water to avoid damaging pump.
1. Depress the Spray Gun trigger.
2. Move the fuel cock to the “ON” position.
3. To start a cold engine, place the choke lever in the “OFF” position. For panel mounted
choke pull to choke. To restart a warm engine, leave the choke level in the “ON” position.
For panel mounted choke models push to run or to start a warm engine.
4. Move the throttle valve lever away from the “LOWER” position, about 1/3 of the way toward the
“UPPER” position.
5. Place the throttle lever halfway between the “UPPER” and “LOWER” settings.
6. Place the engine switch to the “ON” position.
7. For electric start models equipped with s key switch turn the switch to the ON position, for
models with rocker switch start push the rocker switch to ON position. Hold the key in the start
position or the rocker switch in start position until engine starts or for NO MORE than 10 engine
rotations. If engine does NOT start, wait 15 seconds and repeat starting procedures.
8. After starting the engine, move the throttle lever to the “UPPER” position for self-‐‐priming.