Lifan 100-C 2012, Руководство пользователя

Страница: 17 / 22

Check (Fig. 30)
The main cylinder is located at the right
handlebar.
When operating the brake lever, the pads
equipped with caliper will clamp the brake
disc. If any pad is worn to its limit depth,
replace both pads as a set in no time.
Place the motorcycle on the level ground. Check the brake fluid level through
the sight glass. If the fluid level is below the LOWER, loosen the cylinder
cover screws, remove
the cover, add brake fluid up to the UPPER level mark.
Air Bleeding
If the brake lever free play becomes excessive and the brake pads are not
worn beyond its minimum depth, there is probably air in the brake system
and bleed it as follows:
Pump the front brake lever, then gently loosen the bleed valve while holding
the lever. Take care to tighten up the bleed valve as soon as flowing fluid.
Repeat above the procedure until the system is completely bled.
Apply the breke several times and check for free wheel rotation after the
brake lever is released.
WARNING Apply only specified brake fluid, or braking effectiveness
and riding safety will be affected adversely. Do not allow contaminants
such as dirt or water to enter the brake fluid tank. Brake fluid may
cause irritation. Avoid contact with skin or eyes. In case of contact,
flush thoroughly with water.
Rr. brake pedal
Rr. brake arm
Adjusting nut
Pin
Fig. 31
REAR BRAKE
(Fig. 31)
Support the vehicle on its center stand. Measure the distance the rear brake
pedal moves the brake starts to engage. The free play should be 20 30mm.
To adjust, turn the rear brake adjusting nut. Turning it in A direction will
decrease the free play, and in B direction increase the free play.
Apply the several times and check for free wheel rotation after the brake
pedal is released.
NOTE If any pad is worn to its limit depth, replace both pads as a set in no
time. For adjustment of rear brake, refer to adjustment of front brake.
HOW TO CHECK AND REPLACE BRAKE PAD
(Fig. 32)
Unscrew 2 bolts M8, remove the brake caliper, check the brake pads for
wear. If any pad is worn its limit depth, replace both pads as a set.
10-20mm
Fr. brake lever
Brake main cylinder
Sight glass
Screw
Cover
Brake calliper
Fig. 30
Wear limit
20-30mm
Wear limit
Fig. 32
Front brake disc
Front brake calliper
１００－Ｃ（ＥＮＧＬＩＳＨ）ＯＫ．ｐ６５
2012-9-12, 16:27 17